Steep terrain and high rainfall shape earthworks on the North West Coast. 10 listed suppliers are based in Burnie or service Tasmania.
What drives demand in Burnie
- Port works
- Manufacturing plant maintenance
- Forestry logistics
- Mining support
Burnie combines port, forestry, manufacturing, mining services, utilities and civil work across the north west. Suppliers servicing Burnie commonly also cover Wynyard, Somerset, Penguin, Devonport.
Site conditions in Burnie
North West Coast port city with steep terrain and high rainfall. Confirm industrial-site requirements, coastal conditions and support coverage for west-coast projects.
Wet, cold winters slow earthworks; specialist plant may need to cross Bass Strait, so book early.
Machines commonly hired in Burnie
| Class | Size / spec | Typical jobs |
|---|---|---|
| Mini excavator | 1–2 t · ~1 m wide track | Landscaping, footings, pool and plumbing trenches, narrow side access |
| Midi excavator | 3.5–8 t | House sites, driveways, service trenches, small retaining walls |
| Medium excavator | 12–25 t | Civil trenching, bulk dig, dam work, loading trucks |
| Large excavator | 30 t + | Mass excavation, quarry, mining and heavy rock breaking |
| Skid steer / posi-track | 0.7–1.2 m³ bucket | Site clean-up, spreading, trenching and augering with attachments |
| Dozer | D4–D10 class | Bulk push, clearing, dam walls, ripping, rough grading |
| Wheel loader / backhoe | 1–5 m³ bucket | Stockpile handling, truck loading, mixed small civil jobs |
| Grader | 12–16H class | Road formation, pads, final trim and drainage shaping |
Brief the supplier properly
Size to the material and cycle
State the material, estimated volume in cubic metres and where spoil goes. Loading trucks, side-casting and double-handling each point to a different machine size and bucket.
Measure the access, not just the gate
Check gate width, side passage, overhead lines, tail swing clearance and whether a zero-swing machine is needed next to a boundary or live traffic.
Pick attachments up front
Ask for a tilt batter bucket, trenching bucket, auger drive, rock breaker or grab as part of the quote. Adding one on day two usually means another float movement.
Match undercarriage to ground
Rubber tracks protect paving and driveways; steel tracks and wider pads suit soft or abrasive ground. Wet clay can stop a wheeled machine completely.
For Burnie specifically, tell the supplier the exact site address so they can confirm the depot the machine will come from, the travel or float charge and any TAS permit needs.
Licences and rules in TAS
- No High Risk Work Licence is required to operate an excavator, loader, dozer or skid steer, but principal contractors routinely require evidence of competency (RII civil construction units or a verification of competency).
- A general construction induction (White Card, CPCWHS1001) is required for construction work in every state and territory.
- Lodge a Before You Dig Australia (BYDA) enquiry and locate services before excavation. Trenches deeper than 1.5 m trigger additional WHS duties including a safe work method statement.
- WHS regulator for Burnie: WorkSafe Tasmania. Oversize transport: Oversize and overmass permits are issued through the NHVR, with Department of State Growth consent on state roads.
What drives the cost in Burnie
- Float transport in and out (often the biggest line item on short hires)
- Wet hire minimum hours (commonly 4–8 hours per day) and travel time
- Attachments, GPS/machine control and hydraulic hitch charges
- Fuel, cleaning and damage waiver
- Standby rates when rain or other trades stop work
- Distance from the supplier’s depot to your Burnie site
See the plant hire cost guide for indicative 2026 rates.